The commands available to you depend on which mode you are currently in. It may also be used to simply power up the unit using an AC connection.The Cisco IOS user interface is divided into many different modes.
Kit PN number 022083-02 is described on pageģ2 of this manual. Power Supply Interface Kit FCI offers an interface kit that makes it easy to connect to a notebook computer in the field. The PC interface provides a convenient means of capturing zero, spanĪnd trip-point settings in lieu of using the buttons. Access to all level 2 (user configurable) parameters are available through the FC10 PCįlow Rate Indication on PC Interface Units will read values in percent, trend with flow and be repeatable. Password will provide access and allow changes to any level 2 parameters: 19113 Refer to Table 7 for parameter command reference. End user settings are protected with a level 2 password. Password Protection Factory settings are protected with a level 1 factory password. Depending on the computer operating system, installation may be necessary for communication. NOTE: The USB interface cable is supplied with a deviceĭriver disk. Of the 3 configurations above is available from the table on the following page. IMPORTANT NOTE: RS232 RxD, RS232 TxD and SIGNAL RETURN (3-connections) must be used to for effectiveĪn RS232 to 9 pin serial (DB9) to USB interface cable is available from FCI to connect directly to a PC or PLC. 2.5mm phone jack connector - available on remote mount units only 8-wire cable units - for units supplied with cable pigtail, terminate to 3 wires 3. M12 pins - for units supplied with M12 power and output (I/O) connector 2. RS232 signals are available through any of the following:ġ. Depending on the hardware configuration selected, the In both cases the parameters are accessed directly through the RS232 terminals. A Command Line Interface through a HyperTerminal (MS) type program will access all functions and parameters (see RS232 Interface A Windows PC Interface program is available that allows reading and writing to all user available functions and parameters. There are two methods for interfacing through the RS232 connections: 1. This type of communication offersĬonvenient access to all user available parameters. In addition to the button interface, the FS10 may be addressed directly through the RS232 interface. PC Interface and Command Line Interface Configurations
0 kommentar(er)
